Why can’t I get my BluFlame to connect to mQ?

Why can’t I get my BluFlame to connect to mQ?

Why can't I get my BluFlame to connect to mQ?

  • Make sure your Bluetooth is on
  • Make sure the analyzer is not paired in the Bluetooth settings. If it is, "forget this device"
  • Make sure that your analyzer is not currently connected to the BluFlame application. Only one app can be connected at a time.
  • Make sure that your analyzer is configured for iOS even if you have an Android device. measureQuick only uses BTLE
  • Go to the Toolbox and use the +add button to search for the BluFlame. If it does not find it the first time, search again.
  • Tap save and connect.

If you have issues connecting to the app due to a firmware update with a service and calibration done with MRU, you may need to reconfigure the analyzer's Bluetooth settings.

For general Bluetooth connectivity issues on Android, see Bluetooth Troubleshooting: Android Permissions & Probe Connectivity.

    • Related Articles

    • Bluetooth Troubleshooting: Probes & Tools

      A bug preventing some Android devices from detecting Seitron digital manifolds during Bluetooth scans has been fixed. Make sure you are running the latest version of measureQuick. This document provides information to help you with the Bluetooth ...
    • Bluetooth Troubleshooting: Device Permissions & Probe Connectivity

      Need help syncing your Fieldpiece probes after the app was acting up? If you deleted and reinstalled measureQuick and now cannot add your probes, the reinstall cleared your saved probe pairings. Power-cycle each probe and re-pair it; the steps are ...
    • Why does the Bluetooth icon keep changing colors in the Toolbox?

      This is normal as new data comes in. Green = means it is new data Yellow = means data is 1 second old Orange = means data is 3 seconds old Red = means the connection with the probe has been lost The further you are away from the probes and the more ...
    • Probes do not show up when I click "Add" or "Scan" in the Toolbox

      If your probes do not show up when you click Add or Scan in the Toolbox, the cause is usually a Bluetooth or location permission that is turned off on your Android device. Check your device permissions below. Android only. A common issue on Android ...
    • What does the red dot mean in the center of my gauge dial?

      What does the red dot mean in the center of my gauge dial? The red dot means that the probe has lost its connection. measureQuick will hold the last reading for a few seconds to several minutes depending on the particular measurement. For example, ...