"Holding" Measurements when Probes are out of Range

In some situations, you may not be able to stand in one spot and receive signals from your indoor and outdoor probes at the same time. In this situation there is a "Hold" button at the right top corner of the Indoor Measurements and Outdoor Measurements pages. By clicking the "Hold" button, measureQuick holds the measurements received from the probes for that respective page. Once the measurements are held, you can then walk out of range of those probes and the measurements will stay indefinitely. The thing you need to be aware of is that as the conditions change indoors or out, the measurements will not. So when you take your Test In or Test Out snapshot, make sure the held measurements are still accurate because whatever mQ sees when you hit Save Test In or Save Test Out is what you will see on the report weather they're "Held" measurements or live.

Indoor Measurements Page:

Outdoor Measurements Page:

For best results, position probes correctly before your test - see Proper Wireless Probe Placement. If probes disconnect frequently, check Bluetooth Troubleshooting: Android Permissions.

• Related Articles

• What does the red dot mean in the center of my gauge dial?

  What does the red dot mean in the center of my gauge dial? The red dot means that the probe has lost its connection. measureQuick will hold the last reading for a few seconds to several minutes depending on the particular measurement. For example, ...

• Bluetooth Troubleshooting: Probes & Tools

  A bug preventing some Android devices from detecting Seitron digital manifolds during Bluetooth scans has been fixed. Make sure you are running the latest version of measureQuick. This document provides information to help you with the Bluetooth ...

• Bluetooth Troubleshooting: Device Permissions & Probe Connectivity

  Need help syncing your Fieldpiece probes after the app was acting up? If you deleted and reinstalled measureQuick and now cannot add your probes, the reinstall cleared your saved probe pairings. Power-cycle each probe and re-pair it; the steps are ...

• Why does the Bluetooth icon keep changing colors in the Toolbox?

  This is normal as new data comes in. Green = means it is new data Yellow = means data is 1 second old Orange = means data is 3 seconds old Red = means the connection with the probe has been lost The further you are away from the probes and the more ...

• Probes do not show up when I click "Add" or "Scan" in the Toolbox

  If your probes do not show up when you click Add or Scan in the Toolbox, the cause is usually a Bluetooth or location permission that is turned off on your Android device. Check your device permissions below. Android only. A common issue on Android ...