How do I get filter face velocity to show up on the report?

How do I get filter face velocity to show up on the report?

2 points of data are needed for the filter face velocity to show up on the report.
  1. Filter size: With a project open you can find the field under “Equipment Info & System Profile”
  2. Tonnage: This can be found under “Equipment Info & System Profile”

After these data points are entered, the app will use the estimated airflow calculation to determine the filter face velocity.

Keep in mind, the data that you see on the report is snapshot data that is captured from the live measurements and calculations the instant you click the "Save Test In" or "Save Test Out" button. If you save a snapshot before you set the filter size or profile info, the data on the report will not reflect the changes you made to the filter or profile info after you took the snapshot.

    • Related Articles

    • Probes do not show up when I click "Add" or "Scan" in the Toolbox

      A common issue we see on Android devices is that the permissions automatically get turned off with an update or were never on to begin with for the measureQuick app. If you're not familiar with setting app permissions here is how: Go to the "Settings ...

    • Why can’t I get my BluFlame to connect to mQ?

      Why can’t I get my BluFlame to connect to mQ? Make sure your Bluetooth is on Make sure the analyzer is not paired in the Bluetooth settings. If it is “forget this device” Make sure that your analyzer is not currently connected to the BluFlame ...

    • Why can’t I get a green checkmark in my workflow?

      Why can’t I get a green check mark in my project workflow? Open the section and complete all bold black sections or bold red sections of the page. After completing this step, tap “Complete” at the bottom of the page or the check mark at the right top ...

    • "Holding" Measurements when Probes are out of Range

      In some situations, you may not be able to stand in one spot and receive signals from your indoor and outdoor probes at the same time. In this situation there is a "Hold" button at the right top corner of the Indoor Measurements and Outdoor ...

    • Why isn’t data showing up on my Gauge screen, but it shows up in Probe Manager?

      Your probes need to be mapped, mQ does not intrinsically know what part of the air conditioner or refrigeration system that your probes are connected to. So, you need to tell it which probe to reference for specific measurements (ie. low side ...